[Elecraft] K3 Question on KXV3B

[Matt Zilmer]

The KXV3B is a direct replacement for the KXV3 or KXV3A.  No mods are
needed.

73!
matt
W6NIA

On Thu, 21 May 2015 14:22:47 +0000 (UTC), you wrote:

>While reading the K3s FAQ's it says that the new KXV3B Interface board has the new PR6-10 low-noise amplifier (LNA) as part of the circuitry. Further reading suggests that this board can replace the KXV3A board in the K3.  I have not been able to find the "manual" yet as I suspect it is still being edited. I was just wondering if there were any other changes that needed to be made to accommodate the swap as this sounds like an excellent upgrade for the  K3.Bill-W0BBI 
>______________________________________________________________
>Elecraft mailing list
>Home: http://mailman.qth.net/mailman/listinfo/elecraft
>Help: http://mailman.qth.net/mmfaq.htm
>Post: mailto:Elecraft at mailman.qth.net
>
>This list hosted by: http://www.qsl.net
>Please help support this email list: http://www.qsl.net/donate.html
>Message delivered to mzilmer at roadrunner.com

Matt Zilmer, W6NIA
www.elecraft.com
831-763-4211  x129