[Elecraft] K3 Question on KXV3B

[Bill Wiehe via Elecraft]

While reading the K3s FAQ's it says that the new KXV3B Interface board has the new PR6-10 low-noise amplifier (LNA) as part of the circuitry. Further reading suggests that this board can replace the KXV3A board in the K3.  I have not been able to find the "manual" yet as I suspect it is still being edited. I was just wondering if there were any other changes that needed to be made to accommodate the swap as this sounds like an excellent upgrade for the  K3.Bill-W0BBI