[Elecraft] K3 - MCU/FPF/DSP1 Firmware Update Failure

[K M Dailey]

Hi Ross,

Yup, tried that - powered the K3 off, waited 30 secs, powered on and held the Power button down until the red TX light comes on and MCU LD appears - still no comms to the iMac.

Ken


> On 29 Mar 2015, at 14:29, Ross Primrose <n4rp at n4rp.com> wrote:
> 
> Check the owner's manual section on forcing a firmware download....
> 
> 73, Ross N4RP
> 
> On 3/29/2015 9:22 AM, K M Dailey wrote:
>> I just tried to update my K3/P3 with the latest firmware and the process has failed, leaving me with a pretty much dead K3 - MCU, FPF and DSP1 all showing as nothing installed, and the K3 Utility is reporting no comms with the K3.  The K3 itself powers on, but the display is completely blank.
>> 
>> I’m running on Mac OS X 10.10 with the latest K3 Utility.
>> 
>> Any ideas how I can get my radio working again? (:-(
>> 
>> Thanks,
>> 
>> Ken, G0RVH
>> 
>> 
>> 
>> --
>> Ken Dailey
>> 
>> ______________________________________________________________
>> Elecraft mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/elecraft
>> Help: http://mailman.qth.net/mmfaq.htm
>> Post: mailto:Elecraft at mailman.qth.net
>> 
>> This list hosted by: http://www.qsl.net
>> Please help support this email list: http://www.qsl.net/donate.html
>> Message delivered to n4rp at n4rp.com <mailto:n4rp at n4rp.com>
> 
> 
> -- 
> FCC Section 97.313(a) “At all times, an amateur station must use the minimum transmitter power necessary to carry out the desired communications.”

--
Ken Dailey