[Elecraft] Using PR6-10 with KPAK3AUX

[k5oai]

I had RFI problems trying to use the y cable, so I did a work around. Since I
have RX antennas I sometimes need to use through an MFJ 1026 to fight my
local noise problems. So I built a little box with a switch in it. I use 12v
power from an external source (not the back of the K3) When I want to run
the preamp I throw the switch and apply power to the PR6-10. Kind of a round
about way to do it, but it works like a charm.

73 GB,
Sam K5OAI


Ian Kahn wrote
> All,
> 
> I decided to take the plunge this spring and see what 6m is all about.  To
> that end, I purchased a PR6-10 NIB from an estate sale, and am eager to
> get
> it installed with my K-Line. I already have the ACC port on my K3 occupied
> by the KPAK3AUX cable for the KPA500/KAT500.  I'm looking for any
> suggestions on how to get the DIGOUT1 line from the cabling for the PR6-10
> to pin 11 on the ACC port without totally destroying the KPAK3AUX cable. 
> If
> anyone has already done this, and could provide guidance, I'd be very
> appreciative.
> 
> Thanks and 73,
> --Ian
> 
> Ian Kahn, KM4IK
> Roswell, GA  EM74ua





--
View this message in context: http://elecraft.365791.n2.nabble.com/Using-PR6-10-with-KPAK3AUX-tp7600265p7600288.html
Sent from the Elecraft mailing list archive at Nabble.com.