[Elecraft] New K3 build, LOW LOW sensitivity.

[Wayne Burdick]

Joe,

Do you have a KXV3 module installed? You may be switched to the RX antenna.

Wayne
N6KR

On Mar 1, 2015, at 7:48 AM, joemoffatt <joe at selectconnect.net> wrote:

> Everything in the manual checked out ok.  I am at the stage before putting in
> the 100 watt PA.  Just checking things out.   I have the IF Out board, but
> that's about it.  No ATU.   Setup filters, etc.  But, I have only about S1
> on the S Meter, and can only weakly hear the strongest of signals.  Even WWV
> is poor.  This is on a known good antenna/coax.   
> 
> Anyhow, just wondering what to check.  I haven't set the REF OSC yet because
> I can't get a strong enough signal to do it.
> 
> Ideas?   I thought I was sailing along smoothly.   
> 
> Thanks,
> 
> joe
> 
> 
> 
> 
> 
> --
> View this message in context: http://elecraft.365791.n2.nabble.com/New-K3-build-LOW-LOW-sensitivity-tp7599593.html
> Sent from the Elecraft mailing list archive at Nabble.com.
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to n6kr at elecraft.com