[Elecraft] New K3 build, LOW LOW sensitivity.

[joemoffatt]

Everything in the manual checked out ok.  I am at the stage before putting in
the 100 watt PA.  Just checking things out.   I have the IF Out board, but
that's about it.  No ATU.   Setup filters, etc.  But, I have only about S1
on the S Meter, and can only weakly hear the strongest of signals.  Even WWV
is poor.  This is on a known good antenna/coax.   

Anyhow, just wondering what to check.  I haven't set the REF OSC yet because
I can't get a strong enough signal to do it.

Ideas?   I thought I was sailing along smoothly.   

Thanks,

joe





--
View this message in context: http://elecraft.365791.n2.nabble.com/New-K3-build-LOW-LOW-sensitivity-tp7599593.html
Sent from the Elecraft mailing list archive at Nabble.com.