[Elecraft] Filter Offset

[Michael Eberle]

Hold the CONFIG button down to enter the menu.  Then use the VFO B knob 
to locate the FLx FRQ.  So for filter 1 it will show FL1 FRQ and you can 
use the VFO A knob to change the value of the offset if desired.  Tap 
the XFIL key select filters 2 - 5.

Page 46 of the manual gets into more detail than I can here.  If you 
don't have a copy of the manual you can download it from the Elecraft 
website here:

http://www.elecraft.com/manual/E740107%20K3%20Owner's%20man%20D10sm.pdf

Also note that if you have 8 pole filters there should be no offset (set 
it to 0).  The offset only applies to 5 pole filters. Hope this helps.

Mike
KI0HA

On 6/27/2015 9:03 AM, evetsmd wrote:
> I have a K3 SN 6001, I see reference to a filter offset that's related to
> each of the filters
> I purchased with the radio......where do I find that filter offset
> info......
>
>