[Elecraft] Lost in K3 and MMTTY and N1MM setup

[david Moes]

Thanks Rich
your advice was perfect

also found the link I was looking for 
http://www.n3me.net/pdf%20files/N1MM%20-%20Elecraft%20K3%20Setup%20Notes.pdf

David Moes
President: Peterborough Amateur Radio Club.
dmoes at nexicom.net
VE3DVY,  VE3SD

On 1/1/2015 22:02, Richard Ferch wrote:
> Re mode changes - in the N1MM Logger's Configurer window, under the 
> Mode Control tab, for Mode sent to radio for RTTY, set the listbox to 
> AFSK. If it is set to RTTY, the Logger will switch the K3 to FSK D.
>
> Re PTT, there are many different ways to control PTT. If you are using 
> AFSK, you can let N1MM Logger do all the PTT control, either using RTS 
> on the same COM port you use for radio control, or by using software 
> commands, or by using a separate COM port, or from a Winkeyer (N1MM 
> Logger can use the Winkeyer's PTT output in all modes, not just CW). 
> If you opt for any of these methods, MMTTY's PTT & FSK port should be 
> set to NONE.
>
> Alternatively, you can control PTT (and FSK, if you are using it) from 
> MMTTY on a separate COM port, in which case MMTTY needs to be 
> configured to use that port.
>
> How you configure N1MM Logger depends on which method you are using 
> for PTT control. This is all described at 
> <http://n1mmplus.hamdocs.com/tiki-index.php?page=Digital+Setup&structure=N1MM+Logger+Documentation#Setting_Up_the_Configurer>.
>
> 73,
> Rich VE3KI
>
>
> VE3DVY wrote:
>> One issue is mode changes.   when I am using MMTTY and N1MM  it wants to
>> change the mode from AFSK to FSK when ever I change bands or select RTTY
>> mode from N1MM  I have to press DATA MD and change it from FSK-d back to
>> AFSK A
>> also
>> Every time close MMTTY and open it from N1MM  again it forgets that I am
>> using the COM-2 for PTT   it reverts to NONE.    All the other settings
>> like mark frequency seem to hold.
>
>
>