[Elecraft] Lost in K3 and MMTTY and N1MM setup

[Richard Ferch]

Re mode changes - in the N1MM Logger's Configurer window, under the Mode 
Control tab, for Mode sent to radio for RTTY, set the listbox to AFSK. 
If it is set to RTTY, the Logger will switch the K3 to FSK D.

Re PTT, there are many different ways to control PTT. If you are using 
AFSK, you can let N1MM Logger do all the PTT control, either using RTS 
on the same COM port you use for radio control, or by using software 
commands, or by using a separate COM port, or from a Winkeyer (N1MM 
Logger can use the Winkeyer's PTT output in all modes, not just CW). If 
you opt for any of these methods, MMTTY's PTT & FSK port should be set 
to NONE.

Alternatively, you can control PTT (and FSK, if you are using it) from 
MMTTY on a separate COM port, in which case MMTTY needs to be configured 
to use that port.

How you configure N1MM Logger depends on which method you are using for 
PTT control. This is all described at 
<http://n1mmplus.hamdocs.com/tiki-index.php?page=Digital+Setup&structure=N1MM+Logger+Documentation#Setting_Up_the_Configurer>.

73,
Rich VE3KI


VE3DVY wrote:
> One issue is mode changes.   when I am using MMTTY and N1MM  it wants to
> change the mode from AFSK to FSK when ever I change bands or select RTTY
> mode from N1MM  I have to press DATA MD and change it from FSK-d back to
> AFSK A
> also
> Every time close MMTTY and open it from N1MM  again it forgets that I am
> using the COM-2 for PTT   it reverts to NONE.    All the other settings
> like mark frequency seem to hold.