[Elecraft] K3- Synthesizer

[Chris Hallinan]

Ah right. I did follow the thread after the announcement about the new
KSYN3A, just didn't quite sink in. Alphabet soup still has me guessing
sometimes ;)

Thanks all!

-Chris

On Sun, Feb 22, 2015 at 9:20 PM, Phil Wheeler <w7ox at socal.rr.com> wrote:
> You need the updated Synth board and the general coverage filter option in
> your K3.
>
> Phil W7OX
>
>
> On 2/22/15 11:45 AM, Chris Hallinan wrote:
>>
>> OK, I'll ask the "stupid" question.  What is a "syn pwa" and how do I
>> get on 630M with K3?  (Guessing the answers are related!)  I'll skip
>> asking what WSPR mean...I looked it up and found answers.
>>
>> -Chris
>> K1AY
>>
>> On Sun, Feb 22, 2015 at 2:56 PM, Ken Roberson via Elecraft
>> <elecraft at mailman.qth.net> wrote:
>>>
>>> Hello all,
>>> Installed the syn pwa yesterday and ran 630M WSPR beacon overnight.I
>>> should be getting 1mw out of the K3 - however I,m only getting .8 mw.Today I
>>> will run the power cal maybe that will help to get a little morepower out.
>>> The K3 is preforming very nice on 630 meters.set your rx dial to 474.2 -
>>> upper side band .On 630 meters I,m running 5 watts ERP into a 60 ft top
>>> loaded vertical.Check out the WSPR map around 8:PM to10:PM
>>> There are a few photo and a little info on qrz-dot-com.Thanks everyone
>>> 73 Ken K5DNL/WG2XXM
>
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to challinan at gmail.com



-- 
Life is like Linux - it never stands still.