[Elecraft] K3- Synthesizer

[Phil Wheeler]

You need the updated Synth board and the general 
coverage filter option in your K3.

Phil W7OX

On 2/22/15 11:45 AM, Chris Hallinan wrote:
> OK, I'll ask the "stupid" question.  What is a "syn pwa" and how do I
> get on 630M with K3?  (Guessing the answers are related!)  I'll skip
> asking what WSPR mean...I looked it up and found answers.
>
> -Chris
> K1AY
>
> On Sun, Feb 22, 2015 at 2:56 PM, Ken Roberson via Elecraft
> <elecraft at mailman.qth.net> wrote:
>> Hello all,
>> Installed the syn pwa yesterday and ran 630M WSPR beacon overnight.I should be getting 1mw out of the K3 - however I,m only getting .8 mw.Today I will run the power cal maybe that will help to get a little morepower out.
>> The K3 is preforming very nice on 630 meters.set your rx dial to 474.2 - upper side band .On 630 meters I,m running 5 watts ERP into a 60 ft top loaded vertical.Check out the WSPR map around 8:PM to10:PM
>> There are a few photo and a little info on qrz-dot-com.Thanks everyone
>> 73 Ken K5DNL/WG2XXM