[Elecraft] Power output changed in K3

[Phil Wheeler]

Oops, apparently there is!

On 2/22/15 8:53 AM, Phil Wheeler wrote:
> Hopefully there is not a 1 mW power cal :-)
>
> Phil W7OX
>
> On 2/22/15 8:36 AM, Ken Roberson wrote:
>> Not sure that apply to 630M band
>>
>> Ken K5DNL/WG2XXM
>>
>>
>> On Sunday, February 22, 2015 10:02 AM, Phil 
>> Wheeler <w7ox at socal.rr.com> wrote:
>>
>>
>> Yes. Note with 5.10 says " /Those who loaded rev.
>> 5.10 must re-do the 50-Watt gain calibration."
>>
>> /Guess I'd better do that today :-)
>>
>> Phil W7OX
>>
>> On 2/22/15 7:33 AM, Joe Subich, W4TV wrote:
>> >
>> > Did you load one of the recent beta firmware
>> > releases?  Starting with
>> > 5.01 (I think) - certainly in 5.10 there was a
>> > change that required
>> > redoing the TX power calibration.
>> >
>> > 73,
>> >
>> >  ... Joe, W4TV
>> >
>> >
>> > On 2015-02-22 6:26 AM, Johnny Siu wrote:
>> >> Hello Elecrafters,
>> >> I recently discovered that only 20m can deliver
>> >> 90W with all other bands deliver 40-50W.  I did
>> >> a RF power output re-calibration and everything
>> >> is ok now.
>> >> I don't know why this happens?  I did not do
>> >> any changes in configuration before.
>> >> Any ideas?
>> >> 73
>> >> Johnny VR2XMC
>