[Elecraft] Power output changed in K3

[Phil Wheeler]

Hopefully there is not a 1 mW power cal :-)

Phil W7OX

On 2/22/15 8:36 AM, Ken Roberson wrote:
> Not sure that apply to 630M band
>
> Ken K5DNL/WG2XXM
>
>
> On Sunday, February 22, 2015 10:02 AM, Phil 
> Wheeler <w7ox at socal.rr.com> wrote:
>
>
> Yes. Note with 5.10 says " /Those who loaded rev.
> 5.10 must re-do the 50-Watt gain calibration."
>
> /Guess I'd better do that today :-)
>
> Phil W7OX
>
> On 2/22/15 7:33 AM, Joe Subich, W4TV wrote:
> >
> > Did you load one of the recent beta firmware
> > releases?  Starting with
> > 5.01 (I think) - certainly in 5.10 there was a
> > change that required
> > redoing the TX power calibration.
> >
> > 73,
> >
> >  ... Joe, W4TV
> >
> >
> > On 2015-02-22 6:26 AM, Johnny Siu wrote:
> >> Hello Elecrafters,
> >> I recently discovered that only 20m can deliver
> >> 90W with all other bands deliver 40-50W.  I did
> >> a RF power output re-calibration and everything
> >> is ok now.
> >> I don't know why this happens?  I did not do
> >> any changes in configuration before.
> >> Any ideas?
> >> 73
> >> Johnny VR2XMC