[Elecraft] K-Line Programming

[Phil Hystad]

Tom,

Thanks.  I sort of guessed that but I wanted to make sure that there wasn't some source of programming information that I was unaware of.

73, phil, K7PEH


> On Feb 16, 2015, at 9:36 AM, Tom <tomb18 at videotron.ca> wrote:
> 
> Hi Phil,
> While most commands are available in the programming interface, none of the DSP commands are, neither is there any published means to load the firmware.
> Tom
> 
> -----Original Message----- From: Phil Hystad
> Sent: Monday, February 16, 2015 11:27 AM
> To: Elecraft Reflector
> Subject: [Elecraft] K-Line Programming
> 
> Question about programming interface for all the K-Line equipment (including P3 and KAT500)…
> 
> Are the published programming commands totally complete?  In other words, is the published interface sufficient to rewrite all functions of the K3/P3/KPA500/KAT500 utility programs including the firmware updates?
> 
> 73, phil, K7PEH
> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to tomb18 at videotron.ca 
> 
> ---
> This email is free from viruses and malware because avast! Antivirus protection is active.
> http://www.avast.com
>