[Elecraft] K-Line Programming

[Tom]

Hi Phil,
While most commands are available in the programming interface, none of the 
DSP commands are, neither is there any published means to load the firmware.
Tom

-----Original Message----- 
From: Phil Hystad
Sent: Monday, February 16, 2015 11:27 AM
To: Elecraft Reflector
Subject: [Elecraft] K-Line Programming

Question about programming interface for all the K-Line equipment (including 
P3 and KAT500)…

Are the published programming commands totally complete?  In other words, is 
the published interface sufficient to rewrite all functions of the 
K3/P3/KPA500/KAT500 utility programs including the firmware updates?

73, phil, K7PEH

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to tomb18 at videotron.ca 


---
This email is free from viruses and malware because avast! Antivirus protection is active.
http://www.avast.com