[Elecraft] K3 Beta 5r10 and LINK

[Arie Kleingeld PA3A]

Tony

LINK ties both VFO's to the mail freq dial en keeps them insync when you 
turn the dial knob.
So both receivers keep working on the same freq.

What I often use i diversity listening so with two receivers and two 
antennas on the samen freq.
Diversity puts the main RX audio on the left ear of the headset, and the 
Sub on the right ear. That's the normal situation.
In my case, the F9-F12 buttons in N1MM contain commands to the K3 that 
switch the audio to my liking (that can  also be done in the Config, but 
that takes too much time during QSO) This way I can switch listening 
from diversity (listen both MainRX and SubRX at same time) to only main 
RX (main RX audio on both ears)   or only sub RX (Sub RX audio on both 
ears) depending on where the signal is best.
The commands to do this are in the programmers manual of the K3. It's 
really fun to control some beautiful K3 features from the keyboard like 
this.

73
Arie PA3A




N2TK, Tony schreef op 15-2-2015 om 16:38:
> Hi Arie,
> I am not sure I understand what LINK does to help when both receivers are on
> the same freq. What does F9-F12 below do to help?
> Tnx
> N2TK, Tony
.....
> - F9 = listen A-B
> - F10 = listen A-A
> - F11 = listen B-B
> - F12 contains the commands to copy VFO freq and mode from A to B and LINK
> the VFO's.
>
>