[Elecraft] P3 Beta SVGA Inop

[Gerald Manthey]

I could not use the latest beta either. I had to go one beta back.
Gerald KC6CNN
On Feb 2, 2015 7:46 PM, "Jim Miller" <jim at jtmiller.com> wrote:

> Decided to try the latest beta P3 firmware. All loaded including FPGA.
>
> SVGA output is frozen and P3 is updating very slowly.
>
> When I turn the SVGA display enable off the P3 behaves "normally" with a
> proper update rate.
>
> I've removed power from the P3 completely and restarted it with no
> improvement.
>
> Is there something else I need to do?
>
> It was working well before this.
>
> jim ab3cv
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to kc6cnn at gmail.com
>