[Elecraft] Any good/clear "How To" docs on adding the N1MM+ software for Winkey usb smt to my k3+p3 station for windows 7?

Fred Jensen k6dgw at foothill.net
Mon Feb 2 17:30:46 EST 2015


Consulting Vol XLIX of my station notebook:

In the menus at the top of the Entry Window, go to Config.Configure 
Ports etc.

-- In Hardware tab:

-- In the first line, select the COM port for the K3 CAT connection

-- Select "Elecraft K3" from the "Radio" drop down list

-- Leave Digi and CW/Other unchecked

-- Click on Set and select 38400, 8, N, 1, Always OFF, Always OFF. 
Everything else is default.  Click OK

-- In second line, select COM port for the WinKey

-- Radio=none, Digi=unchecked

-- Check CW/Other

-- Click on Set, and select Always OFF, Always OFF.  Check Winkey.  Click OK

-- In Winkey tab:

-- Select options you want

-- Set Keying compensation=8

-- "OK" until you're out of Configuration

-- Call CQ

73,

Fred K6DGW
- Northern California Contest Club
- CU in the 50th Running of the Cal QSO Party 3-4 Oct 2015
- www.cqp.org

On 2/2/2015 1:47 PM, Phil Anderson wrote:
> The K3 build went nicely, no errors; same for the P3. Now just built
> Winkey usb smt to go with N1MM+ to add to the station for contesting.
> The keyer kit itself is working just fine as standalone keyer into K3.
>
> However, I'm finding the documentation for integrating N1MM+ the my Dell
> system 7.0 and keyer with the K3/P3 a bit much. Here I mean integrating
> the N1MM+ software with the above. I'd describe the docs as "circular."
> I'm going in circles. I think I have the hardware hooked up right; that
> is, the Dell recognizes the serial ports, the USB and COM. What's of
> question is the setup/config of the software for SO2V.



More information about the Elecraft mailing list