[Elecraft] K3S rocking on flat surface

[RIchard Williams]

Bob,
I would take a look at the six 2D fasteners you installed in the corners of the RF board.  If one is installed the wrong way, I am betting that would cause the problem you are experiencing.   There are four additional 2D fasteners used (2 on the front panel shield, 1 in the top back corner of the left side panel, and one in the upper read corner of the right side panel), and you might double check they are orientated correctly to.
Dick, K8ZTT

      From: Bob Novas <bob.novas at verizon.net>
 To: elecraft at mailman.qth.net 
 Sent: Sunday, December 6, 2015 8:33 PM
 Subject: [Elecraft] K3S rocking on flat surface
   
I must have done some kit assembly wrong. My K3S does not sit flat on a flat
surface, rather it rocks.  Furthermore, the seam on the bottom between the
front and back cover plates is not flat.  Any hints as to what to look for?
Bob - W3DK

 

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to richarddw1945 at yahoo.com