[Elecraft] K3S rocking on flat surface

[Ron D'Eau Claire]

Try loosening *ALL* of the case screws - bottom covers, front panel, side
panels, rear panel and top, including those around the fan panel (or the
blank panel if you have a K3S/10  - no 100 watt amp), KIO3 and KXV3 panels
on the rear. But DO NOT loosen the screw in the side panel with the feet at
the top rear corner near the ANT 1 connector.  Don't take them out, just
loosen them. 

Then set the K3s on a flat surface and retighten them, standing the rig on
its side feet do to the bottom screws last. 

73 Ron AC7AC



-----Original Message-----
From: Elecraft [mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Bob
Novas
Sent: Sunday, December 6, 2015 7:33 PM
To: elecraft at mailman.qth.net
Subject: [Elecraft] K3S rocking on flat surface

I must have done some kit assembly wrong. My K3S does not sit flat on a flat
surface, rather it rocks.  Furthermore, the seam on the bottom between the
front and back cover plates is not flat.  Any hints as to what to look for?
Bob - W3DK

 

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html Message
delivered to ron at elecraft.com