[Elecraft] RTTY on the K3S

[KE1B]

On Aug 12, 2015, at 5:09 AM, Richard Ferch <ve3iay at storm.ca> wrote:

> Following up on Salvo's post: Rich, I believe you said you are using N1MM+. If that is the case, open the N1MM+ Configurer, select the Mode Control tab, and on the right side, look to see what is selected for "Mode sent to radio" for RTTY. If this is set to RTTY, N1MM+ will put the K3S into FSK D mode, which will result in an unmodulated carrier if there is nothing connected to the FSK pin on the AUX connector on the K3S. To use AFSK A, change the "Mode sent to radio" to AFSK.
> 

That did it, thanks!

Rich KE1B