[Elecraft] Linked VFO's -- usage?

[Arie Kleingeld PA3A]

Don,

to set things up, I use a macro programmed in the F12-key in N1MM to 
copy the freq/mode/BW  From A to B,  switch on the SubRx, set audio to 
A-b listening and Link the VFO's. Switching of the audio is done in 
F9-F10-11 to A-b, A-A, or b-b respectively.

Of course I would like that I could switch the audio when the K3 is in 
diversity mode, but That cannot be done in current Firmware. In 
diversity the audio is fixed to A-b.

73
Arie PA3A

Don Wilhelm schreef op 2-8-2015 om 19:06:
> Arie,
>
> When in diversity, normally both the SubRX and the Main RX are 
> controlled by VFO A.
> You must be in SPLIT to do what you are doing.  Is that true?
>
> 73,
> Don W3FPR
>
> On 8/2/2015 10:34 AM, Arie Kleingeld PA3A wrote:
>> Hi all,
>>
>> I might be one of few people who use the Linked VFO's in diversity, 
>> not that I want to, but because I have to.
>>
>> When listening to diversity I am stuck with the L-MIX-R setting to A-b.
>> Some times I want to switch from A-b to  A-A   or   b-b  and back 
>> again. It is used when I need to listen to only one antenna because 
>> of very weak signal or QRM via the other antenna to my other ear.
>> This switching cannot be done when the K3 is in diversity mode, which 
>> is a pity. That's why I Link the VFO's. (All done with computer macro 
>> commands of course).
>>
>
>