[Elecraft] Transmit Gain Calibration Failed After KSYN3A Installed

Michael Raskin rask1553 at bellsouth.net
Mon Apr 27 16:16:19 EDT 2015


I KNOW this is cockpit error (it always is) so I’m hoping someone can tell 
be what I am doing wrong.  I just installed the two KSYN3A synthesizer 
boards in my K3 main and sub and successfully upgraded firmware to 5.14, and 
performed the installation check:  SYN1 OK and SYN2 OK.  When I tried to do 
the xmit gain calibration at 50 watts, this is the message I received: 
“Xmit gain calibration failed because transmit power did not reach the 
expected value.  50 watt calibration failed.”  I even tried it at 5 watts 
and still didn’t work.  Yes, I cycled K3 off and then on after firmware 
upgrade.

Mike, W4UM 



More information about the Elecraft mailing list