[Elecraft] Transmit Gain Calibration Failed After KSYN3A Installed

[Dave Olean]

I had a similar fail message and found that my filters were not set up 
properly. I did not have the correct filter specified for transmit. The rig 
produced no output. Maybe your filter setup got messed with.  Does your 
transmit work otherwise?
Dave K1WHS

----- Original Message ----- 
From: "Michael Raskin" <rask1553 at bellsouth.net>
To: "elecraft" <elecraft at mailman.qth.net>
Sent: Monday, April 27, 2015 3:34 PM
Subject: [Elecraft] Transmit Gain Calibration Failed After KSYN3A Installed


>I KNOW this is cockpit error (it always is) so I’m hoping someone can tell 
>be what I am doing wrong.  I just installed the two KSYN3A synthesizer 
>boards in my K3 main and sub and successfully upgraded firmware to 5.14, 
>and performed the installation check:  SYN1 OK and SYN2 OK.  When I tried 
>to do the xmit gain calibration at 50 watts, this is the message I 
>received:  “Xmit gain calibration failed because transmit power did not 
>reach the expected value.  50 watt calibration failed.”  I even tried it at 
>5 watts and still didn’t work.  Yes, I cycled K3 off and then on after 
>firmware upgrade.
>
> Mike, W4UM
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to k1whs at metrocast.net