[Elecraft] K3 Signalink and WSPR

[David Cole]

Hi Don,
I am running digital with no interface, using the K3 itself as the
interface.  Seems to work very well with no issues of any kind so far.  

I am NOT a lover of Signalink devices...  I have a friend across the
small valley we live in from me, maybe 1/2 miles away...  The Signalink
craps up the spectrum...  I have another friend, who lives 100 yards
from me, who does NOT use anything, and a K3, and he creates issues only
when I am less than 7 KHz from him.

As an aside, I did a small test using his signal, I took a snapshot
using the P3 prior to replacing the Synths, and one after, with exactly
the same settings on his and my rigs, there is significantly less area
under the curve after the synth swap.
-- 
Thanks and 73's,
For equipment, and software setups and reviews see:
www.nk7z.net
for MixW support see;
http://groups.yahoo.com/neo/groups/mixw/info
for Dopplergram information see:
http://groups.yahoo.com/neo/groups/dopplergram/info
for MM-SSTV see:
http://groups.yahoo.com/neo/groups/MM-SSTV/info


On Sun, 2015-04-19 at 15:57 -0400, Ac2ev wrote:
> Just finished performing the various modifications to make the Signalink USB a much better unit. I've got it all hooked back up and I can TX/RX with it. I.e. I can hear audio and when I tune using WSPR into my dummy load my wattmeter shows output. However when in TX mode the TX audio also plays through the K3's speaker with no volume control. How do I turn this off? I've been searching Google and KE7X's book but I'm not coming up with the right terms to find that pesky setting.
> 
> AC2EV - Don
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to dave at nk7z.net