[Elecraft] K3 Signalink and WSPR

[Ac2ev]

Thanks to WM3M and W3FPR. I completely overlooked that setting. Was busy in the config searching for it.

AC2EV - Don

> On Apr 19, 2015, at 16:06, Don Wilhelm <w3fpr at embarqmail.com> wrote:
> 
> Don,
> 
> It sounds as though you have MON turned up - You can't turn it off with any switch, but you can set it to zero.
> 
> 73,
> Don W3FPR
> 
>> On 4/19/2015 3:57 PM, Ac2ev wrote:
>> Just finished performing the various modifications to make the Signalink USB a much better unit. I've got it all hooked back up and I can TX/RX with it. I.e. I can hear audio and when I tune using WSPR into my dummy load my wattmeter shows output. However when in TX mode the TX audio also plays through the K3's speaker with no volume control. How do I turn this off? I've been searching Google and KE7X's book but I'm not coming up with the right terms to find that pesky setting.
>