[Elecraft] K3 shift and lo/hi cut no longer working

[Chris Hallinan]

Yes, that was the issue.  Thanks, Wayne and all!
Still getting to know my new K3!

73,
Chris - K1AY

On Fri, Apr 3, 2015 at 8:27 PM, Wayne Burdick <n6kr at elecraft.com> wrote:

> Hi Chris,
>
> You probably turned on CW QRQ mode. See CONFIG:CW QRQ.
>
> 73,
> Wayne
> N6KR
>
> On Apr 3, 2015, at 3:34 PM, Chris Hallinan <challinan at gmail.com> wrote:
>
> > Hi folks,
> >
> > Somehow I managed to get my K3 into some state where the shift function
> > doesn't shift, and I'm unable to select the alternate functions of the
> > shift and width knobs to hi/lo cut.
> >
> > Mode CW, VFO-A, nothing unusual.  LEDs show Shift and Width functions
> > enabled.
> >
> > When I rotate Shift, the vfo-b display simply shows FC *0.48 (my pitch,
> the
> > center of the passband.)  It does not shift.  Width control works.  I've
> > power cycled, still no joy.  No software connected, either. Pressing each
> > button does nothing.  (Should go to alternate mode, ie lo/hi cut.  Long
> > pressing shift does normalize.  It's only the functions associated with
> the
> > shift knob.
> >
> > What gives?  What did I do wrong?
> >
> > Chris
> > K1AY
> >
> > --
> > Life is like Linux - it never stands still.
> > ______________________________________________________________
> > Elecraft mailing list
> > Home: http://mailman.qth.net/mailman/listinfo/elecraft
> > Help: http://mailman.qth.net/mmfaq.htm
> > Post: mailto:Elecraft at mailman.qth.net
> >
> > This list hosted by: http://www.qsl.net
> > Please help support this email list: http://www.qsl.net/donate.html
> > Message delivered to n6kr at elecraft.com
>
>


-- 
Life is like Linux - it never stands still.