[Elecraft] CONFIG Question

[Michael Eberle]

The uC 04.86 FW REVS is the firmware revision number.  From this screen 
the VFO B knob should cycle through the config parameters and the VFO A 
knob will cycle through the values available for the selected parameter.

 From the FW REVS screen, if rotate the VFO A knob clockwise a little, 
it should change to something like "d1 02.83" which is the DSP firmware 
revision.  I am curious if it will do this, but not change the frequency 
when you exit the menu.

Mike
KI0HA

On 9/19/2014 11:00 PM, Ron Wetjen wrote:
> When I go into CONFIG the display reads
>
> uC 04.86
> FW REV5
>
> Turning VFO B doesn't change the display (and turning VFO A doesn't 
> change the frequency).
>
> Checked to make sure the VFO LOCK wasn't engaged ... they weren't.
>
> The knobs and buttons all seem to be working.
>
> Thoughts on what to check?
>
> Ron, WD4AHZ
>