[Elecraft] CW on SSB

[Nr4c]

Chk manual page 55 for details.  

Sent from my iPhone
...nr4c. bill


> On May 15, 2014, at 12:12 PM, Edward R Cole <kl7uw at acsalaska.net> wrote:
> 
> I give up...didn't find any "Autoshift" in the menus of either the K3 or KX3.  Is this about some other radio?  Or is a feature of some early vs of firmware long gone?  I'll admit not updating the K3 lately (vs 4.81).
> 
> In doing frequency drift measurements I noted that Frequency seen in USB mode is different than what is seen in CW mode.  The shift appears to be that of the sidetone frequency which I have set to 550-Hz for performing the temperature compensation procedure on the KX3.
> 
> To hear the test signal in USB I have to retune the VFO if I switch from CW.  I have a good ear for tone frequency so am able to tune in the test signal in USB to match the CW sidetone frequency.  That requires moving the dial about 550 Hz.  If on the wrong sideband you will *not* hear it.
> 
> 73, Ed - KL7UW
> 
> ---------------------
> From: Oliver Dr?se <droese at necg.de>
> To: elecraft at mailman.qth.net
> Subject: Re: [Elecraft] CW on SSB
> Message-ID: <5373DE83.5090801 at necg.de>
> Content-Type: text/plain; charset=ISO-8859-1; format=flowed
> 
> 
> And enable auto-shift in the menu when switching from CW to SSB and vice
> versa, otherwise you will still have to retune to get signal into the
> passband again.
> 
> 73, Olli
> 
> Contest, DX & radio projects: http://www.dh8bqa.de
> 
> 73, Ed - KL7UW
> http://www.kl7uw.com
>    "Kits made by KL7UW"
> Dubus Mag business:
>    dubususa at gmail.com
> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to nr4c at widomaker.com