[Elecraft] [P3] New Computer, P3 Utility Doesn't See P3

[Phil Wheeler]

Ian,

Have you independently verified that your serial 
port is working in the new computer with some 
other external device?

73, Phil w7ox

On 3/29/14, 2:50 PM, Ian Kahn wrote:
> Recently I replaced the computer in my shack.  When I did so, I moved the
> PCI serial board from the old computer to the new one.  I then plugged my
> K-line into the same ports on the computer as I originally had them plugged
> into on the old computer (K3 into the integrated port, P3 and KPA500 into
> the same ports on the PCI board).  I then downloaded and installed all the
> latest utilities.  Each utility found its relevant system except for the P3
> utility.  The P3 is plugged into one of two possible ports in the port list
> in the P3 utility.  On either port, all the utility does is scan through
> the various baud rates looking for the P3.  The baud rate on the P3 is set
> to 38400, as are the physical port configurations in Device Manager on the
> PC.  I verified the cables are all connected properly.  I verified the
> ports work properly.  During this whole endeavor I didn't change anything
> in the connections on my K-Line.
>
> If anyone can make any suggestions as to what is causing this issue, I'd
> appreciate it.  Thank you all in advance for the assistance.
>
> 73,
>
> --Ian
> Ian Kahn, KM4IK
> Roswell, GA  EM74ua
> km4ik.ian at gmail.com
> K3 #281, P3 #688, KPA500 #1468
> HRD v5.x/6.0 Test Team
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to w7ox at socal.rr.com
>