[Elecraft] Another K3-SignaLink question

[Joe Harris]

Ed,

See page 20 of the K3 manual, in the Line Out setting. You can set the Line
Out level in Config, or it can be set to =PHONES, which is what it sounds
like you have it set to.

73,
Joe, N1QD


On Thu, Mar 27, 2014 at 3:09 PM, Edward F. Steinfeld <edward at go-embedded.com
> wrote:

> I have just connected my SignaLink to the K3 using SignaLink supplied K3
> cables. I find the Line Out amplitude varies according to where I have the
> AF control set. I would have thought that Line Out was a constant signal
> level. Without setting the AF level quite high I do not get good PSK
> reception. At those levels it is too loud for my ham shack (and my wife).
> What I have I set wrong?
>
> Ed  --  KB1ZJK
>
> Edward F. Steinfeld
> 25 Arbor Glen Drive
> Stow, MA 01775-1258
> Home: (978)897-3127
> Cell: (978)376-3146
> mailto::edward at go-embedded.com
> http://www.go-embedded.com <http://www.go-embedded.com/>
> http://en.wikipedia.org/wiki/Mount_Steinfeld
>
>
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to joseph.a.harris at gmail.com
>



-- 
Joe Harris, N1QD