[Elecraft] HRD/DM-780, Elecraft K3 and soundcard

[Tony Lyon]

Hi Sal,
Yes, I went through the Signalink audio level config again and no change.
The Signalink pots are also set just like yours.

73,
Tony L. (KJ5XF)
> Hi Tony!
> Have you gone through the Signalink audio levels config procedure?
> Is it possible that its just Windows audio levels that are low?
> All my Signalink pots (except Delay) are usually at 12 o'clock.
>
> __________________
> Slava (Sal) B, W2RMS
> W2RMS at arrl.net
>
> On Jun 24, 2014, at 9:47 PM, Tony Lyon <tony.lyon at austin.rr.com> wrote:
>
>> Folks,
>> I decided to try HRD/DM780 for first time after using another HF digital software program for
>> probably 10 years.  I am using an Elecraft K3 and a SignaLink USB interface and both
>> MixW and MultiPSK fine with ZERO problems on either RX or TX. With HRD/DM780 (version 6.2)  the K3
>> will  TX fine (great signal reports), but on RX (with the Audio input set between 50-60%), I only get about
>> 90% copy even with a solid OLIVIA signal in the waterfall. I have tried all kinds of SYNC/TUNE Margins
>> (while using OLIVIA) to no avail. I have also tried all different levels of audio RX input to no avail.
>> If someone could share their SignaLink  and any K3 LINE-IN/LINE-OUT config values to get DM780 to work I
>> would appreciate it. I have been at this for a week (part time) and still can't get DM780 to work correctly
>> with my K3.
>>
>> There is clearly a parameter I am missing, but the documentation for setting up the soundcard for version
>> is 6.2 is a tad vague.
>>
>> 73,
>> Tony L. (KJ5XF)
>>
>>
>>
>>
>> ______________________________________________________________
>> Elecraft mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/elecraft
>> Help: http://mailman.qth.net/mmfaq.htm
>> Post: mailto:Elecraft at mailman.qth.net
>>
>> This list hosted by: http://www.qsl.net
>> Please help support this email list: http://www.qsl.net/donate.html
>> Message delivered to slavka at nullserv.com
>
>