[Elecraft] (no subject)

[Alan Bloom]

Try a parameter initialization.  While holding the LABELS key, tap the 
POWER switch, which will turn the P3 on if it was off.  After about 2 
seconds you should see "CONFIGURATION RESET" on the screen and you can 
release the LABELS key.

Alan N1AL


On 06/24/2014 08:33 PM, Hisashi T Fujinaka wrote:
> Well that was pleasant. I was making a band change (chasing W1AW/3 and
> W1AW/9) and my P3 with P3SVGA went into a screen that said something
> like "Ready to load Firmware." I tried to load the firmware but at the
> power-cycle I got the screen:
>
> =====
>
> ****  FATAL ERROR  ****
> In: ddc_set_coef()
> span=0
>
> Press any active key to escape
>
> =====
>
> I tried again, and the same screen appeared.
>
> None of the keys did a thing. So I power cycled again and saw the same
> screen. I thought removing the P3SVGA might help but reloading and
> resetting gave the same error.
>
> What next?
>
> Thanks.
>