[Elecraft] Fwd: K3 - No Power Out

[Bob KD7YZ]

On 1/26/2014 09:15, Richard Thorne wrote:
>
> I can adjust the power (while Not transmitting) and set it to say
> 12w.  As soon as I transmit the rig display's 0 watts
>

I am late to this thread.
Friday, last, I replaced the two FET, closest to the back,, on the
ten-watt module. Flip K3 over. Take off rear-half of bottom cover.
mid-section and aft for  the two.

Prior to that, when I tried to xmit in any mode on any band other than
my three transverters, I got Main Display, bottom, saying 0 W

it means the ten-watt-module is fried.

Or,, at least in my case, it did.


-- 

Bob KD7YZ
http://www.qrz.com/db/KD7YZ
www.denstarfarm.us/LGD