[Elecraft] Station Monitor

[kc2vmp]

I've been hoping to see the port on the back of the P3 labeled sensor used for something like this.  

73,
kc2vmp

On Jan 17, 2014, at 2:18 PM, Al Lorona <alorona at sbcglobal.net> wrote:

> Wouldn't it be cool if the P3 could display the K3's transmitted signal in the time domain, like an oscilloscope? If this were possible then it might be used to obtain the classic two-tone display in the ARRL Handbook or maybe even the classic trapezoid pattern if somehow the necessary synchronization could be achieved.
>  
> Al Bloom is going, "Oh, no," right now.
>  
> Al  W6LX
> 
> 
>>> I have been considering a "station monitor" to monitor my RF output. 
>>>  I have a 70MHz occilliscope that I would like to place between amp & 
>>> feed line to various antennas.  I want to make sure my CW & SSB  
>>> output is clean without clicks or splatter, especially at higher output.
> 
>>> 73 Mike DeLong KD8RQE
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html