[Elecraft] K3: "XMIT" produces Display "0 W" suddenly

[George Danner]

When My K3 (kit) was about a year old it developed a similar issue.
In my paranoia to not damage the TMP connectors, I had not used enough force 
to press home the TMP located just under the right forward corner (Toward 
the front panel) of the sub-receiver on the main board.
I actually traced the signal to that point!
Now I'm a little less paranoid and make sure the TMP connectors are firmly 
pressed home.
73
George
AI4VZ

-----Original Message----- 
From: Bob KD7YZ
Sent: Friday, January 17, 2014 1:44 PM
To: K3 List
Subject: Re: [Elecraft] K3: "XMIT" produces Display "0 W" suddenly

I have learned from Elecraft that this may be indicative of two blown
FET's in the 10w amp stage inside the K3.

gremlins abound. And all while I was away doing chores outside. Since I
had the dogs with me it must have been the inside cats!


-- 

Bob KD7YZ
http://www.qrz.com/db/KD7YZ
www.denstarfarm.us/LGD

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html