[Elecraft] [KX3} Unable to engage screw into KXFL3

[Greg Troxel]

"James C. Hall, MD" <heartdoc at nwtcc.com> writes:

> I received my filter board for my KX3, but the ½”, 13mm screw will not
> engage the screw hole in the filter board. The screw, which is exactly the
> same as the screw that was already there, barely touches the filter board
> when fully installed. Is there some trick to getting this screw to work, or
> should I look for a longer screw ?

I found that the main board can be in different positions relative to
the case, and that loosening the bottom screws allowed me to move it
around slightly making the hold-down screw fit much better, and then
tightened everything up.

73 de n1dam