[Elecraft] [KX3} Unable to engage screw into KXFL3

[Don Wilhelm]

Jamie,

If the KXFL3 module is installed correctly, the 1/2 inch long screw 
should protrude through the KXFL3 board locking it in place. Make 
certain the KXFL3 board is installed correctly into the header before 
inserting the screw.

73,
Don W3FPR

On 1/11/2014 4:18 PM, James C. Hall, MD wrote:
> Hello:
>
>   
>
> I received my filter board for my KX3, but the ½”, 13mm screw will not
> engage the screw hole in the filter board. The screw, which is exactly the
> same as the screw that was already there, barely touches the filter board
> when fully installed. Is there some trick to getting this screw to work, or
> should I look for a longer screw ?
>
>   
>
> 73, Jamie
>
> WB4YDL
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>