[Elecraft] K2/100 7211 TX Power output meter stopped working

[Mike Sanders]

Sorry that should have been D16 and 17. I'm going to look at the
circuit again and again. 73

             K0AZ
       Mike Sanders
EM37cd SW Missouri
     www.k0az.com






-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Mike Sanders
Sent: Friday, January 03, 2014 7:13 AM
To: Elecraft at mailman.qth.net
Subject: [Elecraft] K2/100 7211 TX Power output meter stopped working

Good Morning, Yeah, not sure what happened but appears when in
high power mode over 10 watts power control does not work either.
It gives full output. I just replaced diodes D1 and D2 1N5711s but
the problem continues the same. Before I get any deeper into this does
anyone have any experience with this failure and any ideas? I sure
thought the diodes would fix this. I triple checked my work and the
orientation of the diodes on the board.  73, Mike K0AZ

             K0AZ
       Mike Sanders
EM37cd SW Missouri
     www.k0az.com







______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html