[Elecraft] [KX3][2M] Assembly Advice - Going Nuts!

[Wayne Burdick]

Chris,

This is not supposed to happen (first case I've heard of), so you could just request a replacement 2-meter module. That said, you could probably re-glue the nut in place temporarily using a tiny bit of epoxy, avoiding the threads. Once the TO220 device tab is secured by the screw, the adhesive no longer serves any function.

73,
Wayne
N6KR

On Dec 20, 2014, at 11:08 PM, Chris Johnson <elecraft at ozy.us> wrote:

> I am installing my third 2M module on a KX3 for a friend.   On this particular unit, the nut that I guess was being held on by some adhesive I never noticed, fell off the back of the FET heat sink.   I’m having a stickler of a time trying to figure out a clever way to hold the nut on there so I can re-insert the board and get the lock screw through the side of the case.  (Figure 20, Page 27)
> 
> Any wise men around have any sage advice?
> 
> /ponder
> 
> Chris
> K6OZY
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to n6kr at elecraft.com