[Elecraft] [KX3][2M] Assembly Advice - Going Nuts!

[Chris Johnson]

I am installing my third 2M module on a KX3 for a friend.   On this particular unit, the nut that I guess was being held on by some adhesive I never noticed, fell off the back of the FET heat sink.   I’m having a stickler of a time trying to figure out a clever way to hold the nut on there so I can re-insert the board and get the lock screw through the side of the case.  (Figure 20, Page 27)

Any wise men around have any sage advice?

/ponder

Chris
K6OZY