[Elecraft] fldigi and K3 frequency readout

[Bill Turner]

------------ ORIGINAL MESSAGE ------------(may be snipped)

On Tue, 16 Dec 2014 07:36:16 +0000 (UTC), you wrote:

>Bill, all you need to do is once you change to digital is hold the mode /alt down until it read rev over the top ofthe digital and that will switch to the other SSB mode.
>Not hard once you done it a few times.  
>
>Good Luck.Bill W0WFH

REPLY:

That's not the problem but thanks for trying. 

The problem is that when the K3 is in either USB or LSB in data-a
mode, the dial freq+audio offset shown in fldigi is incorrect. 

73, Bill W6WRT