[Elecraft] P3 Ubdate

[Don Wilhelm]

Wes,

Are you certain you had all the desired parameters set in the K3 when 
you stored the M1-M4 per band memories?  I find that they do save the 
mode, frequencies, filter settings and antenna selection that you have 
requested.
I don't know about your Split Macro and the LOCK functions or the RX 
antenna because I have not tried those in my setup.

73,
Don W3FPR

On 12/11/2014 12:44 PM, Wes (N7WS) wrote:
> Mea Culpa.  Although I have the latest (I think) pdf K3 manual, some 
> of my research used the printed (and now out-of-date) manual that came 
> with my radio.  I now understand the difference between "NOR" and 
> "Band-Sel".
>
> However, that doesn't negate all of my concerns.  The manual states 
> for example, that antenna selection is remembered.  Perhaps that 
> applies to units with the built-in tuner, but it sure doesn't remember 
> the state of the RX antenna selection.
>
> Other parameters that I believe should be memorized and recalled are 
> ATT, PRE, LOCK, FIL and probably others.  In other words I would like 
> to be able to recover to a previously recorded state.
>
> Now, let's say I use my "Split" macro that locks VFO A, and sets VFO B 
> up 1 KHz and goes into Split mode, while there I fiddle with the 
> Filter selection.  If in M1, Split is off, VFO A = X, VFO B = Y, a FIL 
> is selected and normalized and Lock is off I would like to get this 
> all back by a press of M>V and M1.  As it stands, the VFOs will revert 
> okay but will still be locked and the filter will be what ever it was 
> before.
>