[Elecraft] K3 No Transmit When WAV File Is Played

[Mike K2MK]

Hi Bud,

I'll assume that you have a cable from PC audio out to the K3 Line In. 

Are you using VOX or are you sending a serial signal from your PC to K3 to
transmit. If VOX be sure VOX is on.

Make sure MENU:MIC+LIN is ON

Go into the MENU:MIC SEL and chose LINE IN. Put the K3 into test mode or run
it into a dummy load. Put the K3 into transmit manually with the XMIT
button. Adjust the MIC knob for proper ALC levels on the K3. (You may also
have to adjust the line out level on your PC). After you have completed the
level adjustment remember to turn the MENU:MIC SEL back to your normal
microphone input (front or rear).

73,
Mike K2MK


Bud Governale, W3LL wrote
> When I hit a function key in N1MM the correct wav file plays as heard thru
> the computer speakers.
> 
> However the K3 (in SSB mode) does not transmit.
> 
> Any suggestions?
> 
> 73,
> Bud W3LL





--
View this message in context: http://elecraft.365791.n2.nabble.com/K3-No-Transmit-When-WAV-File-Is-Played-tp7595839p7595840.html
Sent from the Elecraft mailing list archive at Nabble.com.