[Elecraft] PX3 question

[Charlie T, K3ICH]

Waddaya bet some entrepreneur makes a rear box so both can be a single solid 
unit?

Howzatt for cool?

Of course, there's always duct tape.

Chas
----- Original Message ----- 
From: "Howard Hoyt" <hhoyt at mebtel.net>
To: <Elecraft at mailman.qth.net>
Sent: Wednesday, December 10, 2014 12:18 AM
Subject: [Elecraft] PX3 question


> Stan,
>
> If you position the PX3 to the left of the KX3, the two units can be 
> positioned within 0.5" of each other when using all right-angle plugs, 
> which makes the combined chassis width 13.5".
>
> We make a #33-100 KX3 & PX3 DC Power Splitter which helps facilitate neat 
> cable management for users of the KX3 & PX3 
> (https://proaudioeng.com/accessories/). If you are using straight plugs 
> for your headset, you can position them as much as 2.25" apart and still 
> use the splitter.
>
> You could also reverse the positions, in which case if you are using the 
> splitter the PX3 can be positioned up to 1.25" to the right of the KX3, 
> and you would have to use a right-angle BNC for the antenna connector.
>
> An additional 1" or more of separation can be achieved by removing the 
> heatshrink and tape holding the two conductors of the splitter if 
> necessary.
>
> Cheers & 73,
>
> Howie - WA4PSC
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to pincon at erols.com