[Elecraft] KX3-2M post install issue

[Don Wilhelm]

Gene,

Only a possible guess.
You could try a direct Frequency Entry to a frequency in the 2 meter band.
Do it once with VFO A selected and then swap VFOs (A/B button) and do it 
to that VFO as well.

73,
Don W3FPR

On 8/16/2014 5:21 PM, Gene Sochor wrote:
> I just completed the straightforward install of my new KX3-2M 2-meter 
> module in my KX3 s/n 335 with ATU, encountering no issues. (firmware 
> level at 2.12).  The simple configuration setup procedure also went 
> smoothly.  After powering off and on as instructed, however, instead 
> of a new 144 MHz band, I have now added a band which VFOA says is 22.0 
> MHz, and VFOB is showing 44.0 MHz instead of 144.0.  Restored the 
> various settings as they were before the install, powered off and on 
> again, then redid the 2 meter settings, with the same results.  Has 
> anybody else experienced this, or have suggestions?