[Elecraft] KX3-2M post install issue

[Gene Sochor]

I just completed the straightforward install of my new KX3-2M 2-meter 
module in my KX3 s/n 335 with ATU, encountering no issues. (firmware 
level at 2.12).  The simple configuration setup procedure also went 
smoothly.  After powering off and on as instructed, however, instead 
of a new 144 MHz band, I have now added a band which VFOA says is 
22.0 MHz, and VFOB is showing 44.0 MHz instead of 144.0.  Restored 
the various settings as they were before the install, powered off and 
on again, then redid the 2 meter settings, with the same 
results.  Has anybody else experienced this, or have suggestions?

73, Gene N9SW