[Elecraft] Disabling the ANT2 selection

[Doug Ellmore Sr.]

Is there a way I can disable the ANT2 selection on the K3 so it does not go
to ANT2 when I push the ANT button?

I am using a remote ant switch and don't want to make a mistake of pushing
the ANT button and then transmit.

I was receiving some strong signals this morning even when the ANT2 was
selected with no antenna connected.

I guess I could put a dummy load there in case I do a dumb thing...

-- 
Doug Ellmore, Sr.
- Head Coach, Southern HS Cross Country / www.southernathletics.org
- Amateur Radio Operator: NA1DX / P40DE, President Explorers Radio Club -
NA3DX
- doug at ellmore.net / 301-807-2193