[Elecraft] K3 / KXV3 / XV222 Interface SNAFU

[Mark Adams]

Gang,

I just upgraded my K3/100 with the KXV3, K144XV, and FM filter. Everything
has the latest firmware. Here's the rub. My XV222 works FB when connected
to my normal IF radio (FT817) running 0.5W. When I reset the jumpers for
full K3 mW interacing and separate RF in/out and control via a newly made
interface cable, I get no power out indicated on the 222. Switching sounds
good and the trasverter turns on/off with the K3. I've checked the jumpers
in XV222, continuity on my interface cable looking for a short, run through
the menus on the K3 looking for anything odd. The K3 is putting out 1mW per
the display.

I've obviously overlooked something very basic. The 2M module works FB and
the transverter works FB when in non-Elecraft radio mode. I have 2M on TRN1
and 222 on TRN2.

Ideas? Anything?

73,
Mark K2QO
K3 #7470
FN03ra