[Elecraft] KX3 LSB Off Frequency

[Don Wilhelm]

Fred,

If it is "off frequency", then moving the VFO one way or another should 
bring the decoded signal so it sounds normal.

So I doubt it is really "off frequency" because you said it gets worse 
either way you move the VFO.
I would suggest that you be certain the NR and NB are off and try again.
Where do you have the filter width set and where is it centered? The low 
end should be at 300 Hz or a bit below that, and the high end should be 
2400 Hz or greater.

73,
Don W3FPR

On 10/27/2013 2:31 PM, Fred Smith wrote:
> I just received my second KX3 and it seems to have an issue.  On LSB "only"
> it sounds like its off frequency when it shows dead on where it should be.
> Tuning up or down makes it over more so, if you listen closely it seems to
> be on but garbled. Never had this happen on my first KX3 on LSB and on this
> one all other voice modes USB and AM are fine.
>
>